TEC Electric 1.5kW 3ph 4 Pole B35 Foot and Flange 90L Frame AC Motor for 230V or 400V 3 phase supply. Inverter Rated for use with a Variable Frequency Inverter Drive having 1ph or 3ph input and 3ph output, or a fixed frequency mains supply at 50Hz.
Output: 1.5kW at 1430rpm, 230V or 400V, 50Hz 3ph.
Speed Range from Inverter Supply: From 5rpm to 70rpm for 5Hz to 70Hz control, with suitable de-rating at the lower speeds.
Fitted with Electronic Holding brake and emergency hand release handle
Brake Torque 23Nm
Brake Voltage: 205Vdc. (Full wave rectifier)
As Default the brake is connected to one phase and the star point in the motor terminal box which gives the 205Vdc required. However if used with an AC Inverter these brake connections must be connected to a separate 230V 1ph supply to operate the brake as the AC Inverter output is not suitable.
Full Load Current with links in Delta for 230V 3ph: 5.94A.
Full Load Current with links in Star for 400V 3ph: 3.43A. (Default).
Torque: 10.02Nm
Power Factor: 0.74 when mains connected at 50Hz.
Efficiency: 85.3 (IE3)
Terminal box position: Top (default), sides (move feet).
Enclosure rating: IP55
200mm Wide x 397mm Long (Including shaft) x 231mm high overall (Including terminal box)
Foot mount on 10mm holes at 140mm wide x 125mm centres 56mm back from the shaft shoulder: Flange mount on 4 x 12mm holes equispaced on 165mm PCD with 130mm diameter spigot in the 200mm diameter flange
24mm diameter, 50mm long with 8mm key
Construction: Aluminium with removable feet.
Weight is 18kg.
Rated at 40C Ambient.
Ventilation space required at rear cooling air intake.
Thermistor for over-temperature protection.
Part Number: 1.543TECAB35-90-IE3-BM Frame Reference: T3AB-90L1-4-B35
From Jan 1st 2017, three phase electric induction motors with a rated output of 0.75kW to 375kW and efficiency less than IE3 must be equipped with a variable speed drive (Inverter Drive). For exceptions, see EC Commission Regulation 640/2009.